• Home
  • Article Archive
    • Article Archive
    • Digital Archive
    • ENews Archive
  • Advertising
    • Advertising Options
    • Media Kit
    • Editorial Calendar
    • Electronic Files
  • Buyers Guide
    • Buyers Resource Guide
    • 2025 Online Form
  • Subscribe
  • Video Vault
  • Events
    • Webinars
    • Summit
  • Contact
  • Events
  • Skip to main content
  • Skip to secondary menu
  • Advertising
  • Subscribe
  • Contact
  • Events
Plastics Decorating

Plastics Decorating

Todays Decorating & Assembly Source

  • Home
  • Articles
    • Article Archive
    • Digital Archive
    • ENews Archive
  • Advertising
    • Advertising Options
    • Media Kit
    • Editorial Calendar
    • Electronic Files
  • Buyers Guide
    • Buyers Resource Guide
    • 2025 Online Form
  • Subscribe
  • Video Vault
  • Events
    • Webinars
  • Decorating Summit

Hot Stamping

Q&A: Hot Stamp/Heat Transfer Tooling and Application

by Bill Morey, Schwerdtle, Inc. In 2016, are there any "typical" hot stamp or heat transfer applications? If "typical" refers to smooth, flat surface decoration or even raised letter "tip stamping," the answer is yes. Because of the benefits of the completely "dry" process of hot stamping – particularly the wide range of colors and the bright metallic finishes of hot stamp … [Read more...] about Q&A: Hot Stamp/Heat Transfer Tooling and Application

Q&A: Hot Stamping 3D Parts

In the past, plastic elements with a curved part geometry typically have been decorated by means of galvanization, which requires two injection-molded parts. A new process developed by KURZ Transfer Products, L.P., Lexington, NC, allows a single-component panel to be partially coated with a metallic, patterned or pigmented foil. This finishing method, according to Allan Quimby, … [Read more...] about Q&A: Hot Stamping 3D Parts

Hot Stamping for Three-Dimensional Parts

by Allan Quimby, KURZ Transfer Products, L.P.   At K 2013, the triennial international trade fair for plastics and rubber, held in Dusseldorf, Germany, in October, the company Leonhard Kurz, represented in the US by KURZ Transfer Products, L.P., lauched its patented 3DHS finishing process. 3DHS is an abbreviation for three-dimensional (3D) hot stamping. Visitors to … [Read more...] about Hot Stamping for Three-Dimensional Parts

Q&A: Heat Transfer vs. Hot Stamping

by Eric Steinwachs, United Silicone Question: What is the difference between heat transfer and hot stamping? Answer: Hot stamping and heat transfer both require heat, pressure and dwell (time) to apply an image to a part. However, heat transfers are pre-printed images using silkscreened, gravure, flexography or digital printing methods on a release paper or film; whereas, hot … [Read more...] about Q&A: Heat Transfer vs. Hot Stamping

Ins and Outs of Hot Stamping v. Heat Transfer

by Keith Hillestad, United Silicone The hot stamping industry as we know it today began in the 1940s with the introduction of roll leaf, which was hot stamping foils manufactured in roll form. The early hot stamping foils used acetate or cellophane as the carrier. Hot stamping applications greatly expanded through the late 1940s as the first vacuum metalizing of a carrier film … [Read more...] about Ins and Outs of Hot Stamping v. Heat Transfer

« Previous Page
Next Page »




© 2025 All Rights Reserved
Peterson Media Group | [email protected]
785.271.5801
2150 SW Westport Dr., Suite 501, Topeka, KS 66614